MotoWerx
06-05-2010, 06:43 PM
This one is ready to go, come get it while the gettin' is good! :beerchug:
2008 Honda CBR1000RR
Full HRC Electric KIT with traction control, ECU, dash, 2 mode map switch, pit lane speed limiter
Full Akrapovic EVO exhaust
25mm GP Suspension Cartridges set up by Barry Wressell of GP Suspension
Ohlins TTX rear shock set up by Barry Wressell of GP Suspension
2 sets of stock wheels with ABM full floating front rotors and EDR performance light weight rear rotors
CRG Roll Click folding levers
1/6 turn HRC Throttle
LSL clip-ons
Speigler front and rear brake lines
520 chain conversion with DID chain, Drive Systems sprockets
Sharkskinz full bodywork
BMC Air filter
Magic Racing air intakes
Gilles rear sets
HM Quickshifter
Lite-tech keyless gas cap
Brand New (1 Race) EBC pads (their new top of the line ones)
Yoshimura left/right case covers
Woodcraft frame sliders
PUIG Double Bubble wind screen with new spare one
Motor only has approx 1500 miles on it
Clean Title in hand
The motor is bone stock and does not burn any oil common to some CBR's. I just had the ECU mapped by EDR for pump gas with traction control and pump gas with out traction control. This bike runs hard and strong. It is fully safety wired and ready to race. Will also throw in all the stock pieces I have left. (not much but some including rear sets and exhaust)
$10,900 takes it home
http://www.themotowerx.com/Pictures/2008CBR/586782700_thJKp-X2.jpg
http://www.themotowerx.com/Pictures/2008CBR/586779722_BSjNz-X2.jpg
http://www.themotowerx.com/Pictures/2-Fast/869885322_2K8ab-X2.jpg
2008 Honda CBR1000RR
Full HRC Electric KIT with traction control, ECU, dash, 2 mode map switch, pit lane speed limiter
Full Akrapovic EVO exhaust
25mm GP Suspension Cartridges set up by Barry Wressell of GP Suspension
Ohlins TTX rear shock set up by Barry Wressell of GP Suspension
2 sets of stock wheels with ABM full floating front rotors and EDR performance light weight rear rotors
CRG Roll Click folding levers
1/6 turn HRC Throttle
LSL clip-ons
Speigler front and rear brake lines
520 chain conversion with DID chain, Drive Systems sprockets
Sharkskinz full bodywork
BMC Air filter
Magic Racing air intakes
Gilles rear sets
HM Quickshifter
Lite-tech keyless gas cap
Brand New (1 Race) EBC pads (their new top of the line ones)
Yoshimura left/right case covers
Woodcraft frame sliders
PUIG Double Bubble wind screen with new spare one
Motor only has approx 1500 miles on it
Clean Title in hand
The motor is bone stock and does not burn any oil common to some CBR's. I just had the ECU mapped by EDR for pump gas with traction control and pump gas with out traction control. This bike runs hard and strong. It is fully safety wired and ready to race. Will also throw in all the stock pieces I have left. (not much but some including rear sets and exhaust)
$10,900 takes it home
http://www.themotowerx.com/Pictures/2008CBR/586782700_thJKp-X2.jpg
http://www.themotowerx.com/Pictures/2008CBR/586779722_BSjNz-X2.jpg
http://www.themotowerx.com/Pictures/2-Fast/869885322_2K8ab-X2.jpg