GSXR 750 mods!!!!!!!!!!!!

[flyingbutterknife]

Yoda of the motor,I seek knowledge! #1...On my 07 gsxr 750,can I pull off that stupid exhaust motor or do I leave it plugged in? #2....Can I remove that emissions valve thingy on my head and connect the two tubes or do I leave it connected? #3 Is there anything else I need to do before it comes in to get it mapped? #4 what all do I need to purchase for it just to map it for now? I am bringing my 750 to the Thunderhill trackday instead of the r6 and want to do everything possible to speed it up for you when I bring it in to map so I can "get in and get out" and get going to Cali. Be gentle with me and dont use big Yoda terms,I am a simple little guy with low I.Q. and big words give me gas. Sam Verderico A.M.A.

[Ed Who?]

1. yes. remove the motor and leave cable unplugged but you will need to remove the brwn/black wire on the ECU. (i have it written down at shop)

2. yes. just remove, and use two vacum caps on top of the nipples. If you unplug the pair, you will need a 25ohm resistor (i think its 25, Piper might have it on him) again, all at the shop my notes are.

3. Yes. dont touch it!

4. Just need a pipe, good air filter, plug/remove PAIR valve, and PCIII

"Your skin hang off bones like chin on lizard it do yes"

~Yoda

[flyingbutterknife]

Good input, I will pull exup motor and let you cut the wire,plug the pair valve and remove and let you wire in resistor(or I can if you let me know the ohms load),buy pipe and install it(any suggestions on brand?),buy and install pc III,install filter and get the bike to you to finalize.......If I run Vesrah rjl instead of srjl on both bikes would it be that much of a difference or should I stay with srjl pads? Do you have Ohlins damper for my gixxer in stock? Pm me price on damper,pcIII,filter,and anything for my 750 I need,especially anything you have on sale for that bike.....You really are the Jedi knight of portland! Maybe someday I will show you my lightsaber....its big!

[sanfret]

Oh and pick up a 1K motor and shoehorn it in the frame before you bring it down.

[flyingbutterknife]

Oh and pick up a 1K motor and shoehorn it in the frame before you bring it down.

Do you think anyone would notice? Shit,than I could just sneak it into the 600 class and dominate all! :1087:

[piper907]

http://www.edrperformance.com/insider/showthread.php?p=3129#post3129